JP Fluid Control 2 way solenoid valve (type DF-SA) with G 2 inch threads and a 120 V AC coil. The circuit function of the solenoid valve is normally closed (voltage = open) and semi-direct operating, so no pressure differential is required. Suitable for max media temperature of 120° C (248 ° F) pressure range of 0 - 10 bar (0 - 145 psi). Housing of brass with EPDM sealing and a 50 mm orifice. The Kv-value is 40.94 m3/h (682.47 l/min at dp=1 bar water).
Order before 16h CEST (mo-fr), same day shipment
2 year warranty, Returns 30 days
This is a JP Fluid Control semi-direct operating 2 way solenoid valve with G 2 inch threads and a 120 V AC coil. The valve has a brass housing with EPDM sealing and an orifice size of 50 mm (approximately 2 inch). The circuit function of the solenoid valve is normally closed, which means the valve opens when voltage is applied.
The valve is suitable for pressures of 0 - 10 bar (0 - 145 psi) and a maximum temperature of 120° C (248° F). The valve has a Kv-value of 40.94 m3/h, which translates to a flow rate of 682.47 l/min at a differential pressure of 1 bar (for water). In imperial units: Cv = 47.33, which means 47.33 GPM @ 1 psi pressure drop. For simple applications it is often enough to select a valve based on the thread size and orifice diameter. For more accurate sizing, use the Kv-value with our easy to use valve sizing calculator.
The brass housing is durable, suitable for neutral fluids and resistant to many chemicals. The EPDM (ethylene propylene diene monomer rubber) sealing is suitable for neutral fluids and many chemicals, but it has poor resistance to oils and fats. Consult our chemical resistance chart to verify compatibility of housing and seals with the medium. The valve has an IP65 rating if properly connected.
The DF-SA is a semi-directly operated 2/2-way solenoid valve (normally closed). The valve has an orifice from 16 mm up to 25 mm. The DF-SA series operates from 0 bar and is suitable for medium flow rates. The body is available in brass or stainless steel with an NBR, EPDM or FKM seal. The DF-SA solenoid valves are compatible with the coils from the CS2 (up to 1 inch) and CS8 (from 1-1/4 inch) series.
The valves are available with BSP or NPT threads on request.