6mm - R1/8" 1.9mm Elbow Orifice Fitting

Notice: This product is discontinued

Discontinued
6mm - R1/8" 1.9mm Elbow Orifice Fitting
6mm - R1/8" 1.9mm Elbow Orifice Fitting
6mm - R1/8" 1.9mm Elbow Orifice Fitting
Image may vary slightly
See specifications for accurate information.
Reference: PL6-01-1p9
Brand: Pisco

This is an elbow 1.9 mm orifice fitting used for air flow control. It is designed to fix the air flow rate by restricting it with a significantly smaller orifice in the threaded side of the fitting. It has a 6 mm push-in fitting on one side and an R 1/8 inch male threaded port on the other side. Also suitable for vacuum applications at a pressure of -1 bar (-14.5 psi). It has NBR seals that make it suitable for applications within a temperature range from 0 to 60 °C (32 to 140 °F).

View all

Notice: This product is discontinued

Description
Specifications
Downloads

This is an elbow 1.9 mm orifice fitting used for air flow control. It is designed to fix the air flow rate by restricting it with a significantly smaller orifice in the threaded side of the fitting.

It has a 6 mm push-in fitting on one side and an R 1/8 inch male threaded port on the other side. The push-in fitting provides an easy connection with the tubing. Push the tube in and the fitting will fix it with stainless steel claws.

Also suitable for vacuum applications at a pressure of -1 bar (-14.5 psi). It has NBR seals that make it suitable for applications within a temperature range from 0 to 60°C (32 to 140 °F) (no freezing).

Pros:

  • Simple design
  • Small installation place
  • Lower cost than a throttle (needle) valve
  • Suitable for vacuum applications
  • Equipped with easy to connect push-in fittings

Cons:

  • Non-adjustable orifice size
  • Dust could damage the pneumatic system if vacuum is applied without a filter on the inlet side

PL series

The PL – series includes elbow brass/PBT orifice fittings designed for air flow control. The threaded fitting side for all fittings is male threaded R1/8 inch with 18 different possible orifice fitting sizes ranging from 0.3 to 2.0 mm. The push-in fitting sizes range from 4 to 8 mm. These flow restrictors are suitable for a maximum operating pressure of 10 bar and -1 bar for vacuum. These orifice fittings are sealed with NBR O-rings that make them suitable for temperatures ranging from 0 to 60°C.