JP Fluid Control 2 way solenoid valve (type ST-SA) with G 1/2 inch threads and a 120 V AC coil. The circuit function of the solenoid valve is normally closed (voltage = open) and semi-direct operating, so no pressure differential is required. Suitable for max media temperature of 130° C (266 ° F) pressure range of 0 - 16 bar (0 - 232 psi). Housing of brass with EPDM sealing and a 10.5 mm orifice. The Kv-value is 1.49 m3/h (24.84 l/min at dp=1 bar water).
Order before 16h CEST (mo-fr), same day shipment
2 year warranty, Returns 30 days
This is a JP Fluid Control semi-direct operating 2 way solenoid valve with G 1/2 inch threads and a 120 V AC coil. The valve has a brass housing with EPDM sealing and an orifice size of 10.5 mm (approximately 3/8 inch). The circuit function of the solenoid valve is normally closed, which means the valve opens when voltage is applied.
The valve is suitable for pressures of 0 - 16 bar (0 - 232 psi) and a maximum temperature of 130° C (266° F). The valve has a Kv-value of 1.49 m3/h, which translates to a flow rate of 24.84 l/min at a differential pressure of 1 bar (for water). In imperial units: Cv = 1.72, which means 1.72 GPM @ 1 psi pressure drop. For simple applications it is often enough to select a valve based on the thread size and orifice diameter. For more accurate sizing, use the Kv-value with our easy to use valve sizing calculator.
The brass housing is durable, suitable for neutral fluids and resistant to many chemicals. The EPDM (ethylene propylene diene monomer rubber) sealing is suitable for neutral fluids and many chemicals, but it has poor resistance to oils and fats. Consult our chemical resistance chart to verify compatibility of housing and seals with the medium. The valve has an IP65 rating if properly connected.
The ST-SA valve is a semi-directly operated, normally closed 2/2-way solenoid valve. The ST-SA series can be used from zero bar. The body is available in brass and stainless steel with an NBR, EPDM or FKM seal. The orifice is 10.5 mm for the brass valves, and 8 mm for the stainless steel valves. The ST-SA solenoid valves are compatible with all coils from the CS1-series.
The valves are available with BSP or NPT threads on request.