No products found with current parameters. Try to go back and adjust/reset the filters or select another product category below.
This copper sealing ring is used between a pressure gauge and mating surface to prevent leakage. Designed for G 1/8 inch male connection point located below or in the rear of the pressure gauge. Seal has an internal diameter of 4.1 mm and an outer diameter of 8 mm. It is a profile seal allowing for the correct orientation of the pressure gauge readout. It is internally centered.
Order before 16h CEST (mo-fr), same day shipment
2 year warranty, Returns 30 days
This copper sealing ring is typically used as a mechanical seal between a pressure gauge and mating surface to prevent leakage. They are often times considered gaskets. It is meant for connection sizes of G 1/8 inch. It has an internal diameter of 4.1 mm, outer diameter of 8 mm, and a height of 2,7 mm. It is a profile seal, meaning it has the advantage to turn an additional 1/2 or full rotation after a proper seal has been made. This allows for the correct orientation of the pressure gauge readout. It is internally centered and relies on the pressure gauge centering pin. For additional centering information, please refer to the datasheet.
The ML-S seal series it ideally used as a mechanical seal (gasket) between a pressure gauge and the mating surface to prevent any leakage. Designed for G 1/4, G 3/8, or G 1/2 inch connections. Profile seals (internally or externally centered) or flat seals are available. Profile seals are recommended to allow for extra rotation for proper gauge readout orientation.